Role overview
About this role
Based on the EU Regulation (EC) 216/2008 the EU Commission has issued amongst others Regulation (EC) 1702/2003. Annexed to this Regulation is Annex Part 21 setting forth in Section A the Requirements for applicants and acquired rights and obligations. The training course will address the legal and regulatory system as defined through (EC) 216/2008. Presented in detail will be those Subparts of Annex Part 21 applicable to ETSO Authorisation. Also the alternative procedures per 21A.14b and AMC 21A.14b, as applicable to Design Organisations carrying out the ETSO design activities, are explained. <br />An example of the Declaration of Design and Performance, DDP, will be presented and guidance material provided regarding minor and major changes and repairs to ETSO articles and in particular to seats.<br />The different options regarding the issuance of the Permit to Fly by either the Competent Authority or by the approved Design Organisation will be explained. An important aspect of Annex Part 21 is Continued Airworthiness, e.g. Mandatory Continuing Airworthiness Information system by EASA and the required reporting by all parties of in-service difficulties, incidents and accidents. This subject will be addressed in a dedicated session.<br />The EASA Internal Working procedure for ETSO Authorisation as well as the Internal Working procedure applicable to Design Organisations applying for design approval under the alternative procedures will be addressed as well. At the end of the training course the attendees should have a good understanding of all the steps necessary to obtain an EASA ETSO and the tasks and responsibilities of the Design Organisation. The hand-out material for this training course consists of the consolidated version of Annex Part 21, the consolidated version of the AMC & GM, EASA Internal Working procedures and the power point presentations all in hard copy. Courses held on location at the customer's request can be re-structured to allow a dedicated training based on specific needs. Click here for more information. <br />Content <br /> <br />Learning Objectives: At the end of the training course the attendees should understand: The Design Organisation alternative procedures approval process, The ETSO Authorisation process.<br /> <br />Target Group: <br /> <br />Duration: 2 days, starting at 9:00 and ending at 17:00 on both days.<br /> <br /> Click on the apply button to view further information on each course <br />